You have to look up into the dash from below to see it.ģ) Ground pin 1 of the Data Link Connector by taking a wire or paper clip and running it from pin 1 to pin 4. Here is a quick HowTo on programming your own keyless entry:Ģ) Locate the Data Link Connector, its a black 16 pin connecter that is under the driver's side dash, right where your right knee would be. Remove the ignition key in order to exit the Program Mode
Perform the previous step to program up to four transmitters (including your old ones).ġ1. Press the LOCK and UNLOCK buttons together on the keyless entry transmitter and hold until the vehicle beeps twice to verify that the transmitter has been successfully programmed (this take approximately 15 seconds).ġ0. The vehicle will sound three beeps in order to verify the Program Mode has been activated.ĩ. (Do not turn the ignition key in the lock cylinder.) Leave the ignition key in the ignition lock cylinder.Ĩ. Insert the ignition key into the ignition lock cylinder. (Do not turn the ignition key in the lock cylinder.)ħ. Insert the ignition key into the ignition lock cylinder and remove the key. (Do not turn the ignition key in the lock cylinder.)Ħ. Press and hold the driver side door lock switch in the UNLOCK position.ĥ. If you need further assistance with your keyless entry system, then seek out a professional, such as one from Your Mechanic, to help you.4. If the key is not starting up the engine or locking the doors, then the key may be different all together and you would need to get a new key. If the engine starts up after these steps, then the key fob is successfully reprogrammed to your vehicle. If the doors will lock then put the key in the ignition switch and try to start the engine.Take the key out of the door and with the door shut, try to unlock the doors with the remote.Unlock and lock the door with the key and push the lock and unlock buttons on the key fob at the same time - (do this 3 times).
Remove the key from the ignition switch.Turn the key to the ’ON’ position and unlock the door with you hand and the remote at the same time.Turn the key to the ’ON’ position and lock the door with you hand and the remote at the same time.Put the key in the ignition and turn the key to the ’ON’ position.Remove the battery cables from the vehicle, wait 30 seconds, then hook them back up (reset computer).Remove the battery from the key fob and put it back in (unless you put in a new battery).In this case, if the key can go into the doors and unlock them, then you would need to do the following: You could reprogram a key fob to a different vehicle as long as the key is the same for the vehicle.
0 kommentar(er)
